M-2464 & M-2464 - Translating Tube Maching Screw Models

Home

Services

Contact Us

Site Map

(800) 236-2554

All-Lift, All The Time
For over 30 Years!

M-2464 & M-2465
Translating Tube Machine Screw Models

Dimensions

Specifications

Model M-2464 is self lowering and a motor brake should be used.
Model M-2465 may drift .75 in. (20:1 ratio) to 2.0 in. (5:1 ratio) when motor is shut off. If this is undesirable, a motor brake should be employed.

General Features: Rotating Screw and Translating Tube Models

Integral 56 frame, C-face mounting flange.
Three-piece flexible coupling for easy motor assembly (included).
Four threaded holes in base for standard hydraulic cylinder, clevis end accessory attachment. Tapped 1/2-20 UNF-2B.
Rolled thread lifting screw, with work hardened finish, reduces coefficient of friction between screw and lifting nut. Provides smooth, efficient operation and long service.

Steel worm and bronze gear set for quiet operation. Available in 5:1 and 20:1 ratios.
Rugged, lightweight aluminum housing is corrosion-resistant.
Bronze lifting nut for longer life.
Standard grease fitting on housing for easy lubrication of worm gear.
Stop-pin at end of lifting screw prevents inadvertent run-off of lifting nut.

General Features: Translating Tube Models
Outer aluminum tube is corrosion-resistant and protects translating tube, lifting screw and nut. Wiper scraper seal in end of outer tube keeps dirt out and lubricants in. Bronze guide brushing inside of outer tube reduces lateral movement of translating screw. Translating tube is zinc coated for weather-resistance.	Single or double lead lifting screw and nut for high efficiency and long wear. Vent in outer tube prevents pressure build-up in the actuator. Furnished with standard clevis end. Threaded end is available; and on special order, depending on application, and type of threaded connection may be substituted.

All drawings and dimension are for informational purposes only and
are subject to change.