BM-2462 & BM-2463
Rotating Ball Screw Models

Dimensions

Specifications

1. Model BM-2462 and BM-2463 are self lowering and a motor brake must be used.
2. Due to the high travel speed of BM-2462, it is important that a brake with a minimum response time be used.  An independently controlled direct acting brake (6 ft/-lb for 3/4 HP motors and 3 ft.-lb. for smaller motors) is recommended.

• Integral 56 frame, C-face mounting flange.
• Three-piece flexible coupling for easy motor assembly (included).
• Four threaded holes in base for standard hydraulic cylinder, clevis end accessory attachment.  Tapped 1/2-20 UNF-2B.
• Ball-bearing type heat-treated screw and mating nut with rolling contact reduces friction to a minimum providing capability for higher speed and longer life with less power requirement.

• Steel worm and bronze gear set for quiet operation.  Available in 5:1 and 20:1 ratios.
• Rugged, lightweight aluminum housing is corrosion-resistant.
• Standard grease fitting on housing for easy lubrication of worm gear.
• Stop-disc at end of lifting screw prevents inadvertent run-off of ball nut.