|
Aero-Motive
Reels, Balancers |
|
Coffing Hoists
Hoists, Hoist
Repair |
|
CM Hoists
Chain
Hoists, Wire Rope, Ratchet Levers, Trolley
|
|
Conductix
Power and Data Transfer Systems |
Demag
Overhead Cranes
Hoists and Winches Gearmotors
Ergonomic Systems |
|
Duff-Norton Mechanical
Actuators, Rotary Unions, Electromechanical Actuators |
|
Equipto
Storage Systems |
|
Hilman Rollers
Riggers Sets |
Harrington Hoists
Chain & Wire Hoists |
|
Joyce/Dayton
Jacks, Actuators |
|
Lyon
Tool Storage, Locker Units
|
|
Perfecting Coupling |
|
Ram-Pac
Hydraulic Tools
|
Stanley Bostitch
Pneumatic Tools, Fasteners
|
Simplex
Jacks and Braces |
|
In-Plant Offices, Mezzanines
|
 |
| |
|
Structural
Pipe Fittings
The Wall Flange is designed to provide
a base fitting for railings requiring a side mounted fixing.
The upright cannot pass through the fitting. |
 |
The Rail Bracket is designed to secure
handrail pipe to a wall. It can also be used on the top of a
wall to secure a lower rail. Pipes cannot be joined inside
this fitting. |
 |
The Side Outlet Tee is designed to
provide a three way joint for handrails and other
structures. The center pipe cannot be joined inside the
fitting. |
 |
The 4 Way With Center Tube is designed
to provide a four way connection to an upright. The center
pipe cannot be joined inside the fitting, but it can end
inside the fitting and be capped using a Series 1085. |
 |
The Short Tee Swivel is designed to
provide corner joints with angles varying from 90 to 180
degrees. Sold in pairs. |
 |
The 30 to 45 Degree Adjustable 2 Socket
Cross is designed to fasten the middle rail to an
intermediate upright, which must remain vertical. It can
accommodate slope angles from 30 to 45 degrees.
|
 |
The Variable Angle Tee is designed to
fasten top rails to end uprights on slopes from 30 to 60
degrees, or any tee joint requiring this range of angle. |
 |
The Collar is designed to be used as a
support fitting for a Series 1048 when it is used as a
hinge. It can be used to increase the load capacity of
another fitting or as a stop on a telescoping pipe or tube. |
 |
The Gate Eye, used in conjunction with
a Series 1070, is designed as the female section of a hinge
for a lightweight gate. For heavy gate installations, a
Series 1048 in conjunction with a Series 1068 is
recommended. |
 |
The Gate Hinge, used in conjunction
with a Series 1069, is designed as the male section of a
hinge for a lightweight gate. For heavier gate
installations, a Series 1048 in conjunction with an Series
1068 is recommended. |
 |
The Hook is designed to provide
attachment for a chain. |
 |
The Fixing Pad is designed to provide
attachment of flat sheets of lightweight metal, plastic or
wood to pipe structures as backing or flooring. It may also
be used as a gate stop. A Series 1073 is an alternate
fitting. |
 |
More Kwik-Fit Parts
|
|
Back to BlueWater Manufacturing Products |
|
